Bags & Filters

How to Change a SEBO Bag and Filters, Model by Model

Where the bag sits, what the bag-full light means and when each filter is due on the SEBO FELIX, DART, AUTOMATIC X7/X8, AIRBELT E, D and K canisters and BALANCE A1. Every step comes from SEBO's U.S. owner's manuals.

10 min read
SEBO 8334AM Service Box for the AIRBELT E: eight AeraPure bags with green collars, a green-framed pre-motor filter and an exhaust microfilter with red latches

SEBO says its filter bags can be changed in just a few seconds. The trick is knowing where each family hides the latch: a flip-up flap on the FELIX and DART, a lift-off front cover on the AUTOMATIC X, a release catch on the AIRBELT canisters.

Every step below comes from SEBO's U.S. owner's manuals, as of November 2026. For part numbers, see SEBO bags by part number; for which box to buy, see SEBO service box or bags only.

Key takeaways

  • Unplug before you open anything. On the BALANCE A1, disconnect the battery.
  • Cap the full bag before lifting it out. A cover that won't close usually means the bag isn't seated.
  • The indicator also reacts to clogs and very dirty filters. On AIRBELT canisters, read it at full power.
  • Filters keep their own schedule: about 10 to 20 bags on most models, 20 on the AUTOMATIC X7 and X8.
  • Never wash SEBO filters, reuse bags, or run the vacuum without its bag, filters and covers in place.

When is each SEBO filter due?

Each bagged SEBO here filters in three stages: the bag, a pre-motor filter that SEBO says captures dust particles from the airflow of the vacuum before it passes over the motor, and an exhaust microfilter that cleans the air on its way out. SEBO calls this tightly sealed hospital-grade filtration, which depends on every filter being seated and every cover fully closed.

When SEBO says to act, by model (SEBO U.S. manuals and product pages, checked November 2026)
Model Bag-full warning Pre-motor filter Exhaust filter
FELIX, DART Orange gauge on the bag housing lid After 10 to 20 bags Extremely dirty, or about 15 to 20 bags
AUTOMATIC X7, X8 Red light; shuts off after 30 seconds Extremely dirty, or about 20 bags After 20 bags
AIRBELT E1, E2, E3 Orange indicator; motor shuts off if ignored Extremely dirty, or about 10 to 20 bags After 10 to 20 bags
AIRBELT D1, D4 Orange window in the lid; motor shuts off if ignored Extremely dirty or clogged; no bag count given After 10 to 20 bags
AIRBELT K2, K3 Amber light; motor shuts off when hot After 10 to 20 bags Extremely dirty, or about 10 to 20 bags
BALANCE A1 (bagless) Display shows E3 and the machine shuts off Not stated by the maker Not stated by the maker

SEBO's how-to videos page sums up the filter rule as usually every 10 to 20 bags and has short bag and filter videos for several models.

Changing the bag and filters on a FELIX or DART

The FELIX and DART manuals give the same steps. With a full bag, a clog or an excessively dirty microfilter, an indicator window on the bag housing lid fills with orange and a bypass valve opens to protect the motor.

  1. Unplug, stand the vacuum upright, pull the cover release flap upward and open the cover.
  2. Seal the bag with its sealing cap and lift it out by the sealing plate.
  3. Lower a new 7029AM bag into the holder so the 4 small tabs, marked by arrows, fit their grooves. Each bag carries a placement diagram.
  4. Push the cover down firmly and snap the flap into place.

Pre-motor filter (7012AM): after 10 to 20 bags. With the bag out, pull it out by its handle and slide the new one down into the bottom of the bag housing until it snaps in. If a new bag won't fit into position, SEBO says to check this filter.

Exhaust filter: the fabric wrapped around the machine, which SEBO says also absorbs motor noise. Change it when extremely dirty or after about 15 to 20 bags: remove the retaining rings, pull its strips out of the housing slot, then wrap the new one around the machine, pulling it taut, press its strips firmly into the slot and refit the rings. SEBO warns that a badly fitted filter is ineffective. FELIX exhaust filters are made for each machine color; the DART has its own.

AUTOMATIC X7 and X8 bag and filter changes

The X7 and X8 share one manual and the 5093AM bag. A full bag, a clog or an excessively dirty microfilter turns on the red bag-full or clog light, and the vacuum shuts off after 30 seconds. A flashing light means it already has.

  1. Unplug, pull the cover release flap forward and lift off the front cover. SEBO says the flap must stay pulled out while you change the bag.
  2. Squeeze the clamps on both sides of the sealing plate, slide the bag out and push its cap on.
  3. Slide the new bag's sealing plate into the holder and push it in firmly.
  4. Refit the cover, push it forward and push the flap down to lock it. SEBO suggests storing the bag cap inside the housing, below the bag.

Pre-motor microfilter (5036AM): when extremely dirty or after about 20 bags. With the front cover off, slide it out at the bottom, then lift the safety lever and slide the new one in along its tracks, plastic ridge facing you.

Exhaust microfilter: after 20 bags. Squeeze the filter door release buttons toward the middle, remove the cover, unhook the filter tab and pull the filter out. Slide the new one in closed end first, fit its opening to the air channel and hook the tab on, then slide the cover down until it clicks.

AIRBELT E1, E2 and E3: bag and filter steps

All three E models take the 8300AM bag and the same filters. The indicator on top turns orange; ignore it and the motor shuts off, usually within 6-10 minutes. At lower power levels it may read incorrectly, so check it at full suction.

  1. Unplug, lift the filter bag release catch and open the cover.
  2. Seal the bag with its cap, tilt the green collar up and lift the bag out.
  3. Slide the new bag's sealing plate vertically into the holder so the U-shaped metal spring sits in the collar's slot, then tilt it back.
  4. Close the cover until it snaps shut. It will not close if the bag is in wrong.

Pre-motor filter: when extremely dirty or after about 10 to 20 bags. With the bag out, pull it out and up by the tab at its bottom. Insert the new one horizontally and swing it down until the tab locks.

Exhaust microfilter: after 10 to 20 bags. Press the cover release buttons together and pull the cover off. Pull out the fabric, press the red latches inward and remove the filter. Fit the new one with the red alignment tab at the bottom, push until the latches click, tuck the fabric in and snap the cover shut. The 8322AM filter set holds both filters; the 8334AM service box adds eight bags.

AIRBELT D4 and D1: bag and filter steps

The D4 Premium and D1 Turbo share one manual and the 8120AM bag. The indicator is a window in the top lid that turns orange. With a clog, an overflow valve opens and after about 8 minutes the motor shuts off. Read it at full power. The D4's rotating LED is not a bag gauge: it tracks the suction setting.

  1. Unplug, lift the cover release catch and raise the cover.
  2. Seal the bag with its cap, tilt the green collar up and pull the bag out.
  3. Insert the new bag's green collar vertically, line up its slots with the tabs and push it flat until the center U-shaped clip moves all the way forward. Close the cover until it snaps shut.

Pre-motor filter: no bag count is given; change it when extremely dirty or clogged. Pull it out by its rubber rim and press the new rim snugly into the groove all the way around.

Exhaust microfilter: after 10 to 20 bags. Hold the release button on the filter holder, turn the holder counter-clockwise and pull it out. Pull the rubber strip off its notches, fit the new filter so the notches meet the holes in its red strip, tuck the peak down and turn the holder back in. Both filters come as the 8191AM D Filter Set.

SEBO 8191AM filter set for the AIRBELT D: a fabric exhaust microfilter edged with a red rubber strip and a flat oval pre-motor filter with a black rubber rim, in front of the box
The 8191AM D Filter Set: exhaust microfilter (left) and pre-motor filter (right). SEBO photo.

AIRBELT K3 and K2: bag and filter steps

The K manual puts the amber light on top, near the power knob. Ignore it and the motor overheats and shuts off; SEBO says it can be restarted after approximately 30 minutes. Check it at full power, too.

  1. Unplug and stand the canister upright. Press the cover release catch and lower the cover.
  2. Slide the green sealing plate from the holder and push the bag cap on.
  3. Push a new 6629AM bag's sealing plate into the holder slots until it locks, and close the cover.

Exhaust filter: when extremely dirty or after about 10 to 20 bags. Lay the canister flat, lift the catch in the upholstery nozzle recess and remove the printed top cover. Pull the filter out by its handle; refit with the handle toward the upholstery nozzle.

Pre-motor microfilter: after 10 to 20 bags. With the bag out, slide the inner cover up out of its grooves and swap the filter. The 6696AM K Filter Set holds both filters, and SEBO also offers an optional HEPA pre-motor microfilter.

BALANCE A1 cordless: emptying the bin and changing filters

The BALANCE A1 is bagless: cyclones separate the dirt, then the motor protection filter and the micro-hygiene filter catch the finest particles. Its manual says to empty the dust container when dirt reaches the MAX level:

  1. Disconnect the battery and press the adapter release button to remove the adapter.
  2. Over a trash can, pull the dust container release lever halfway. The lid pops open.
  3. To wash the container, pull the lever all the way down, clean it with warm water and mild detergent, and air-dry it for at least 24 hours.
  4. Check that the non-return flap in the air duct under the container moves freely, then snap the container back.

The cyclone unit twists off counterclockwise. Wipe it with a soft microfiber cloth and clear its six intake holes, but never wash it. Behind it, the motor protection filter pulls out by its handle, and the micro hygiene filter comes free when you rock its housing rim. SEBO gives no interval: if the display shows E3, empty the container and replace filters if needed.

SEBO bag and filter questions

How do I know when my SEBO bag needs changing?

When the bag-full or clog indicator comes on. SEBO's manuals add that fine dust may call for an earlier change, while hair or fluff can overfill a bag before the indicator reacts.

Do I change the filters with every bag?

No. Most last about 10 to 20 bags, 20 on the AUTOMATIC X7 and X8, or less if a filter becomes extremely dirty.

Why is the light still on with a new bag?

The indicator also reacts to a clog or an excessively dirty filter. Unplug and check the hose, wand and floor tool, then the filters. Our bag indicator guide covers each check.

Can I wash SEBO filters or reuse a bag?

No. SEBO's manuals say not to re-use filter bags or wash and re-use filters. On the BALANCE A1, the dust container can be washed, but never the filters or the cyclone unit.

Keep reading: SEBO vacuum bags by part number · SEBO service box or bags only? · When to change bags and filters, by brand

Sources: SEBO owner's manuals: FELIX, DART, AUTOMATIC X7/X8, AIRBELT E, AIRBELT D, AIRBELT K, BALANCE A1; SEBO pages: FELIX, AUTOMATIC X7/X8, AIRBELT D, AIRBELT K, BALANCE A1, filtration system, standard features, how-to videos; SEBO catalog, January 2024 (checked November 2026).

Something wrong on this page? Email info@avonvacuums.com with the URL.

Family-owned in Avon, CT · Since 1972

Find the right fit for your vacuum

Use the bag finder or ask our parts counter to confirm your model before ordering bags, filters, or parts.